Aspirating Head System Tri Clamp

Remote Stainless Steel Tri Clamp Aspirating Head System

DESCRIPTION

  • This sampling system is completely fabricated in AISI 316 rated stainless steel.
  • Microbial sampling is programmed through the control unit (TRIO.BAS, AIRBIO, MULTIFLEX) which is generally located outside the isolator cabinet, RABS or inside/outside the cleanroom.
  • The Operator must insert the plate with the culture media into the separated aspiration chamber.
  • The TRI-clamp device simplifies all the operations of cleaning/sterilization.
  • The risk of contamination associated with Operator activities is reduced.
  • The aspirating chamber can be manipulated in multiple directions, according to the unidirectional airflow.
  • The Remote Head System is fully sterilizable.

Note
All TRIO.BAS air samplers are suitable for 90 mm Petri dish or 55 mm Contact plate. In case of conversion from Petri dish to Contact plate or the other way around, it is necessary to adopt the specific aspiration head because they have different configuration. It is also necessary to adjust the position of the fixing spring inside the aspiration chamber of the sampler. This information is valid for both stainless steel aspiration head (see Code 330 and 331) and sterile ”Daily Shift” aspiration head (see Code 340 and 341) .

IDENTIFICATION CODES

Code TRIO.BAS Remote Stainless Steel Tri Clamp (*)
184 silicone tube with 2 clamps ends - 50 cm lenght
185 silicone tube with 2 clamps ends - 100 cm lenght
186 gasket for TRI CLAMP 187 s/s TRI CLAMP closing cap
188 s/s elbow short tube 90° with 2 clamps end - size wheelbase 40 mm
189 s/s tube with 2 clamps end - 50 cm lenght
190 s/s tube with 2 clamps end - 20 cm lenght
191 REMOTE HEAD SYSTEM CONTACT - s/s Aspi Head chamber with aspirating head and 1 tube clamp end for 55 mm Contact plate
192 REMOTE HEAD SYSTEM PETRI - s/s Aspi Head chamber with aspirating head and 1 tube clamp end for 90 mm Petri plate
193 s/s tri clamp with silicone gasket
194 s/s tube with 2 clamps end - 10 cm lenght
195 s/s elbow 90° tube with 2 clamps end - size wheelbase 88,90 mm, radius 25,40 mm
197 s/s hexagonal pipe hook with gaskets and adaptor
198 s/s wall connection with 2 clamps end
199 s/s floor pole - diameter 25 cm, 1 mt height

(*) different sizes on request

Need more informations?